I hope this may save others from giving up or spend as many hours as I did.I solved this by pure lock and being stubborn, I don't know much about linux in general so if this don't work for you I can't be of further assistance. The GUI way to change font is still not working, If I open that it shows all fonts as size 12 and if I change any and hit apply or save the fonts are all reset back to 12, I conclude GUI font-setting is defective.ĭoing the work I also found two settings of fontsize 12 in the mgc_style.tcl file close to the end, but they do not seem to have any influence to GUI, properly only used in some tcl command mode. (Never spend enough time to figure out how to add fonts to ubuntu). font type sans-serif was changed to as fc-list showed that I do not have a font called sans-serif. textfonfV2 is set to -18 to fix the additional editor unvisible font. The small font was changed in the hidden file /home/peter/.modelsim line PrefDefault where I changed all 12 to 18 or 20. Setup environment variable MODELSIM to point to /home/peter and cp the modelsim.ini from the installation directory to /home/peter then do chmod +w modelsim.ini, second I set variable MODEL_TECH to point /home/peter/intelFPGA/17.1/modelsim_ase/bin this fixed the library problem. I found that beside running above instruction I had to do the following: PATH to modelsim was added by the installation script but other needed environment variables are NOT set as needed. Normally I start Modelsim in the folder where I want/have the work library. My problems may relate to the fact that I did not install Quartus only Modelsim-altera, but I do not thinks so.Īlso I do not use project files only do files to compile and simulate. Actually there where two problems, because modelsim did not read in all the standard libraries. Table 1 provides information allowing you to choose which library is needed to compile for VHDL and Verilog.Finally after spending a lot of hours I managed to get it fixed.
After you select the folder and library, click Compile.įor more information on using the Mentor Graphics ModelSim simulator tool, refer to Mentor Graphics ModelSim software documentation and the Mentor Graphics ModelSim and QuestaSim Support (PDF) chapter in volume 3 of the Quartus II Development Software Handbook.Select the specific library folder that you created in Step 2: Create a New Library and look in the for the sim_lib to compile.Go to Compile, and then select Compile.Step 3: Compile the Library and Design File Run the QuartusLiteSetup program after double-clicking it might take a bit longer than you expect to start up. You’ll need the Quartus software, the ModelSim software, and the CycloneV qdz file. This step will create the library folder and map the library. To install the software on your own PC, grab the Quartus 17.0 software from the class website. Note: Repeat Step 2: Create a New Library for more libraries. Type lpm_ver in the Library Name column, then click OK.Go to File menu, select New, and click the library.ModelSim SE/PE Software Step 2: Create a New Library
0 kommentar(er)
